Quartz stone countertops If the workers are installed like this, you can avoid acceptance.
Now the most complicated part of the entire home renovation is the kitchen, not only the overall layout to be considered, but also every detail. The quality of the countertops directly affects the quality of the entire kitchen decoration, so the choice of materials for the countertops is very important. At present, the commonly used countertop materials are natural stone, artificial stone, quartz stone, stainless steel and acrylic. Quartz stone has become the first choice. Quartz stone countertops are not directly produced by quartz stone manufacturers. To the user's home, countertop processing is also required, and some uncertain factors may appear in the processing. Therefore, it is very important to check the acceptance of the countertop after installation!
Quartz stone plates are not cut after natural mining, but are die-cast by quartz stone manufacturers through production equipment. They are new artificial stone products, also known as synthetic stones. Quartz stone is a brittle polymer composite material with certain thermal expansion and contraction characteristics, and has certain mechanical properties such as shrinkage stress, impact toughness and elongation at break. When the sheet cannot withstand the internal stress caused by thermal expansion and contraction. When there is a serious external impact, it will burst, so you should be careful not to bury hidden dangers in the processing of the countertop.
The hardness of quartz stone plate is higher than the Mohs hardness of 6 grade, which causes certain difficulty for processing. Therefore, the seamless splicing of quartz stone countertop should be explained before purchase. Because the seamless splicing of quartz stone is more complicated, the processor will In addition, the fee is used. The so-called seamless splicing is that the seam is 50 cm away from the table. If it is white, use a dry rag to wipe the seams to see if it is tarnished. Open the hole, see if the four corners of the hole are rounded, and check whether there are small cracks around the hole, and whether the bottom is surrounded by a pad. Check whether the expansion joint is reserved between the table and the wall. The gap should not exceed 5mm but not less than 3mm. Before installation, the workers will reconfirm the drawings and the size of the countertops. The cabinets will be adjusted to make the cabinets at the same level. If the workers will confirm these details before installation, you can use them safely after installation.